language

News

FAQ

Home page

Hanging noodle equipment production of common faults and processing methods

Time：

14 Dec,2023

Most of the daily use of hanging noodle equipment often appear some unavoidable small problems, analyze the common faults of hanging noodle equipment and treatment methods to ensure the output of the production line noodles and noodle quality.

1. Calendering section running edge or uneven thickness on both sides, which is caused by the inconsistency of the gap between the two ends of the rollers, to properly adjust the gap between the two ends of the rollers, adjust the uniformity can be solved.

2. Hanging surface is curved wave shape, this reason is because the scraper and cutter and comb knife installation angle is too large, need to be adjusted appropriately can be solved.

3. The panel is often stained with rollers because of excessive moisture in the billet, and another factor is that the scraper bolts are loose.

4. The length of the noodles on the pole is uneven, the reason is to cut off the knife and the automatic pole chain hook displacement, can be appropriate to loosen the upper frame sprocket bolts so that the automatic pole and chain match.

5. When processing can not break the noodles, mainly because of the broken surface of the mouth of the knife blade and the bottom plate does not match, appropriate adjustment of the position can be solved.